Water Heater Installation in Elkhorn, NE

Sizing it for your household, not the last owner's

The single most common mistake we find in Elkhorn homes is a 40-gallon tank serving a house that grew. Sizing comes down to peak-hour demand — how much hot water gets used in your busiest sixty minutes — not to the number printed on the old label.

• 1–2 people, one bathroom — 30 to 40 gallon tank
• 3–4 people, two bathrooms — 40 to 50 gallon tank
• 5+ people, or a soaking tub — 50 to 75 gallon tank, or tankless
• Simultaneous showers plus laundry — high-recovery gas or a properly sized tankless unit

What a code-compliant install includes

An install is not finished when the water gets hot. The list below is what Water Heater Repair Elkhorn works through on every job, and it is where a rushed swap shows up two years later.

• Correct venting — category, slope, length and termination verified, not reused on faith
• A thermal expansion tank where the house has a closed system (nearly all newer Elkhorn subdivisions do)
• A T&P discharge pipe run to a safe termination, full-size and unthreaded at the end
• Dielectric unions or approved connectors so copper and steel are not left to corrode against each other
• A drain pan and drain line on any heater above a finished space
• Seismic and combustion-air clearances observed
• Sediment trap on the gas line
• Old unit drained, disconnected and hauled away

Tank or tankless?

Tankless makes sense when you have the gas supply and venting to support it, you run out of hot water regularly, or you want the floor space back. Tank makes sense when the budget matters more than the endless supply and the existing venting works. We will quote both rather than steering you.